I was thinking it would be nice if we could make Bobcad use some rounding for drill size if we wanted if my hole is a .281 it would be nice if I could tell the system to crap my 9/32 drill .2812 if say I have a .344 hole it would be nice if the system would use my 11/32 drill .3438 . Just nice with all the even number stuff Bobcad always crabs what I want.
1 Like
I agree, something like that would be useful, that the system would reference the standard drill chart and the tool selection options would be determined based on the drill chart instead of making up drills that are not standard. It would also eliminate the need to edit the none standard drills for the standard drills.
Also along the same thought, for tapping Bodcad always has default a 1/4-20 tap. It would be good if the system would populate taps based on the holes that were selected for tapping wizard, I believe this has been mentioned previously in the forum, but, thought this was a good opportunity to bring it up again.
Hope it is considered by BobCad.
David.
1 Like