Post variable to disable tool length compensation

BobCAD-CAM Software Discussions
#1

There is a post variable to inform the post engine to disable tool length compensation?
I know, and I use, rtcp_code_on and rtcp_code_off, which in my case place G43.4 and G49.

G49 is used for G43, and G43.4 so is it correct to use rtcp_code_off for either?

#2

There is not a specific variable to use other than the rtcp_code_off. Normally when it’s needed to cancel the length offset at the end of operations it is simply hard coded using " " in the 197, 198, and 199 post blocks.

HTH

Alex

1 Like