V6 post for Bystronic laser

BobCAM for SOLIDWORKS Discussions
#1

I have a post I have been trying to get working correctly.I have everything but 1 thing working good.

  1. I need the post to turn off the laser at the end of the last line of the contour ( I have it working).
  2. Next I need the comp cancel line output on the next line (Working)
    3.Then on the next line I need the G00 code followed by the next x,y start point. This is what I need help with. I get the G00 on a line but then the post outputs the x,y coordinates on the Following line.
    Bystronic laser 6.BCPst (27.1 KB)
#2

You have already contacted the posting dept for this correct? I just want to make sure you have spoken to someone. Don’t want to leave you hanging :slight_smile: